SOLUÇÕES INOVADORAS
DE SUPORTAGEM
siFramo 100

Pivot Joint GE F 100/160

Aplicação

Applicable as a bracing element for single-arm cantilevers in conjunction with siFramo 100/160 section, and for the knee-brace reinforcing of all frame constructions. The pivot can be installed with angles from 25° to 155°.

Configuração

Pivot Joint GE F 100/160 with pre-attached 100/160 joining plate

Instalação

Attachment of the Joints to the 160 mm face of Beam Section TP F 100/160 by means of 4 Self Forming Screws FLS F at the base plate. The support profile TP F 80 or TP F 100 (depending on joint type) plugged onto the octagon is also attached by means of 4 Self Forming Screws, so 8 Self Forming Screws are necessary in total. The cutting length of the support profile can be determined by the table below-mentioned. After installation at the desired angle the screws have to be tightened with 40 Nm.

Dados Técnicos

Typ
Height H
[mm]
Length L
[mm]
Width B
[mm]
Angle α
GE F 160 - 80 140 160 160 25° - 155°
GE F 160 - 100 180 160 160 25° - 155°


Cutting length c of support profile between two joints:


b [mm]
1000
b [mm]
1500
b [mm]
2000
b [mm]
2500
b [mm]
3000
α c [mm] c [mm] c [mm] c [mm] c[mm]
25° 2140 3323 4506 5689 6872
30° 1792 2792 3792 4792 5792
35° 1549 2420 3292 4164 5035
40° 1370 2148 2926 3704 4482
45° 1236 1943 2650 3357 4065
50° 1133 1786 2438 3091 3744
55° 1053 1663 2273 2884 3494
60° 990 1567 2145 2722 3299
65° 941 1493 2044 2596 3148

a =
horizontal length of distance from centerline of joint at steel structure to profile side of connection 100/160
b =
length of cantilever from connection to centerline of joint
c =
cutting length of support profile between two joints
α =
angle at the opposite of the vertical bracing

Material:
Steel, HCP
TypG
[kg]
Verp.
[Stück]
Artikel-
Nr.
GE F 160 - 803,61 115854
GE F 160 - 1004,31 115855